Shopping Cart
Your Cart is Empty
Quantity:
Subtotal
Taxes
Shipping
Total
There was an error with PayPalClick here to try again
CelebrateThank you for your business!You should be receiving an order confirmation from Paypal shortly.Exit Shopping Cart

WOODEN-IT-BE-NICE

Stephen M. Jornov - Owner/Craftsman

All BOXES ARE CUSTOM MADE TO ORDER. THEY ARE MADE TO THE SIZE REQUIREMENTS AS WELL AS THE WOOD(S) DESIRED AND ANY INTERIOR OR EXTERIOR TREATMENT REQUIREMENTS.

*********************************************************************************************

Front View of Wedding Card Box

Box is made from Maple, Walnut, Birdeye Maple Veneer and Walnut Veneers and is 13-1/2" Long x 10-1/2" Wide x 7" High. Top has Three Sections of Birdseye Maple Veneer and Two 7/8*" wide Walnut Veneer Stripes. Corners are Solid Walnut with Three 3/8" wide Walnut strips inlaid all around the sides of Box . Slot for Wedding Card is 3/8" High x 10-1/2" long. Finish is Three coats of Waterbased Polyurethane.

Price: $ 250.00 - $ 400. depending on materials selected

Top View of Box

Top has Three Section of Birdseye Maple Veneer and Two 7/8*" wide Walnut Veneer Stripes.

Interior View of Box

Interior of Box has Two 1/4" Rare Earth Magnets to hold it shut and two decorative Hinges on back. Hinges stop the lid at 95 degrees. Interior can have a Liner applied if desired. Bottom of box has a rubber anti slip pad on each corner.

 Box can be made with a slot on opposing sides to hold slats to support a removable tray. Dividers can also be made for the box as well. All this can be installed after the box has been used at the wedding so the box has a double useage as a storage box.

Identification Holder

Picture shows a typical setup for the box at a wedding. Holder can be placed on Top of box (as shown) or in Front of the Box. Cards are slipped thru the slot

/
Lightbox image